FEATURES
STYLIZED OTTOMAN
Wide Heavy Gauge Links.
Built-in Articulating Elevated Mid-Ottoman .
GEOMETRICALLY BALANCED
Geometry used to balance chair operation.
HANDLE/LEVER ACTIVTED & GRAVITY OPERATED
Handle/Lever used for release only.
DIRECT DRIVE WITH DOUBLE LOCKS
Direct Drive with Double Over-center-locks.
MINIMUN STACKUP
Flatter links supporting chair.
Wider base mounting points.
METAL GLIDER BASE DESIGN
Welded angle base construction.
EXQUISITE BALL BEARING GLIDE
SUSPENSION
EXTENDED LIFE RIVET JOINTS
Acetal and Bronze rivet bushings .
Nylon stop pin bushings.
INTERCHANGEABLITY WITH OMEGA RECLINERS

BENEFITS
Strength ,durability ,and Safety.
Maximum safety and comfort .
Consistent and easy operation for any person.
Ease of operation & comfort.
Maximum synchronization of sides Positive locking of both sides.
Greater bending resistance.
Greater stability and strength .
Reduced wear and increased durability.
Reduced noise.
One Frame.

COMMENTS
Profile shape designed for safety and appearance without pinch points.
Articulating design allows use of wider & higher mid-ottoman for elimination of entrapment areas and for leg support.
Occupant's weight used to balance operation instead of springs. Therefor , the opening ,closing , ottoman firmness , and back balance while reclining vary with the weight of the occupant making the operation consistant from one person to the next . Springs are used for locking and the initial start of the opening .
Occupant's weight opens chair, handle/lever only unlocks mechanism. Slight footrest pressure closes ottoman.
Square drive tube connects to and controls both left & right sides .
Ottoman is locked closed on both sides.
Improved weyght capacity and durability (250 pound occupant Weight ).
Mechanism base width is closer to seat width while maintaining sufficient clearance between links to eliminate possibility of interference.
Heavy gauge angle cross members are the strongest available.Glide feet caps prevent the chair from sliding on the floor during the glide motion.
Eight ball bearings used in the glide suspension insure an effortless , smooth glide motion,and the longest life available today.
All rivet joints have either acetal(Delrin) or Bronze bushings and acetal spacers to
eliminate any steel-to-steel contact.
No metal-to-metal noises when links contact stop pins.
All Recliners are interchangeable in the same frame if the frame is constructed for Rocker and Two-Motor Lift.